Basic set leveling system transparent 3 mm, order no 12550

This set is no longer available.

As alternative we recommend:

> 50 pulling hoods transparent for tile thickness 3 - 12 mm Art. 12508

> 250 Basic threaded tabs 3 mm joint width Art. 12515

>> Click here for the category Levelling system <<

Levelling system Basic set transparent 3 mm, art. no. 12550

Our basic set is now also available with transparent draw hoods and 3 mm threaded lugs!

Scope of delivery:

• 50 transparent draw hoods
• 250 Threaded lugs, 3 mm
• as always in the practical mixing bucket

With the new basic set you can:

• Lay tiles and natural stones flat and without complaints - on walls and floors
• with exact 3 mm joint course
• the transparent synthetic material leaves no residue on the tiles

Application of the levelling system:

1. Place the first tile in the freshly prepared adhesive bed. Before laying the tiles, make sure that the substrate is perfectly prepared and level. After the first tile has been placed in the adhesive bed, take the threaded lugs and place them with the base plate under the first tile. Depending on the tile format, you can insert several basic threaded lugs along the edge of the tile. The next tile is then inserted so that the threaded lugs are fixed in the joint between them.
2. Once the first row of tiles has been laid, the transparent draw hoods can be screwed onto the threaded lugs. If the draw hoods are not tight at first, fine adjustments can be made at a later stage. Do not tighten the hoods until you can no longer reach them without stepping on the tiles.
3. Finish laying the tiled floor and allow the adhesive bed to harden completely. The transparent draw hoods can then be turned off and reused. Your tiled floor is now perfectly laid.

This set is no longer available.

As alternative we recommend:

> 50 pulling hoods transparent for tile thickness 3 - 12 mm Art. 12508

> 250 Basic threaded tabs 3 mm joint width Art. 12515

>> Click here for the category Levelling system <<

Levelling system Basic set transparent 3 mm, art. no. 12550

Our basic set is now also available with transparent draw hoods and 3 mm threaded lugs!

Scope of delivery:

• 50 transparent draw hoods
• 250 Threaded lugs, 3 mm
• as always in the practical mixing bucket

With the new basic set you can:

• Lay tiles and natural stones flat and without complaints - on walls and floors
• with exact 3 mm joint course
• the transparent synthetic material leaves no residue on the tiles

Application of the levelling system:

1. Place the first tile in the freshly prepared adhesive bed. Before laying the tiles, make sure that the substrate is perfectly prepared and level. After the first tile has been placed in the adhesive bed, take the threaded lugs and place them with the base plate under the first tile. Depending on the tile format, you can insert several basic threaded lugs along the edge of the tile. The next tile is then inserted so that the threaded lugs are fixed in the joint between them.
2. Once the first row of tiles has been laid, the transparent draw hoods can be screwed onto the threaded lugs. If the draw hoods are not tight at first, fine adjustments can be made at a later stage. Do not tighten the hoods until you can no longer reach them without stepping on the tiles.
3. Finish laying the tiled floor and allow the adhesive bed to harden completely. The transparent draw hoods can then be turned off and reused. Your tiled floor is now perfectly laid.

• Print this page