Vertical edge clip "Base" for pedestal supports | no. 12583
Vertical edge clip "Base" for vertical installation of terrace tiles for steps and terminations | no. 12583
The edge clip is used to create vertical (upright) finishes when laying terrace tiles in outdoor areas.
Also for creating steps and risers.
Properties:
- Vertical edge clip "Base" for 2 cm thick tiles
- Simple, fast application
- For the creation of vertical facings on steps and end edges
- The clips prevent the vertical tiles from slipping
Application:
For laying vertical tiles and slabs you need Art. 12582 edge clip "head" and Art. 12583 edge clip "base". To create vertical edges, attach the "Head" clip and the "Base" clip at the top and bottom of the pedestal support. Fasten the "Head" clip to the pedestal support plate with silicone, remove the joint spacers from the pedestal support plate beforehand (only necessary for pedestal supports installed at the edge). Now push the tile vertically into the fixture at the clips (the tile must be 2 cm thick). This way the step or landing is finished cleanly and exactly. With the help of the adjusting key (art. 12533) the terrace tiles can be adjusted to the correct level.
The edge clips art. 12582 and 12583 are only suitable for the following pedestal supports:
Pedestal support fixed head:
- Article 12525
- Article 12526
- Article 12527
- Article 12532
Pedestal support self-levelling head:
- Article 12528
- Article 12529
- Article 12530
- Article 12534
- Article 12535
Vertical edge clip "Base" for vertical installation of terrace tiles for steps and terminations | no. 12583
The edge clip is used to create vertical (upright) finishes when laying terrace tiles in outdoor areas.
Also for creating steps and risers.
Properties:
- Vertical edge clip "Base" for 2 cm thick tiles
- Simple, fast application
- For the creation of vertical facings on steps and end edges
- The clips prevent the vertical tiles from slipping
Application:
For laying vertical tiles and slabs you need Art. 12582 edge clip "head" and Art. 12583 edge clip "base". To create vertical edges, attach the "Head" clip and the "Base" clip at the top and bottom of the pedestal support. Fasten the "Head" clip to the pedestal support plate with silicone, remove the joint spacers from the pedestal support plate beforehand (only necessary for pedestal supports installed at the edge). Now push the tile vertically into the fixture at the clips (the tile must be 2 cm thick). This way the step or landing is finished cleanly and exactly. With the help of the adjusting key (art. 12533) the terrace tiles can be adjusted to the correct level.
The edge clips art. 12582 and 12583 are only suitable for the following pedestal supports:
Pedestal support fixed head:
- Article 12525
- Article 12526
- Article 12527
- Article 12532
Pedestal support self-levelling head:
- Article 12528
- Article 12529
- Article 12530
- Article 12534
- Article 12535